LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Suspension System-General Information) >> General Procedures >> Wheel Bearing Inspection - Front and Rear

Wheel Bearing Inspection - Front and Rear

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle until the tire is off the floor. For additional information, refer to JACKING & LIFTING .
    2. NOTE: Make sure the wheel rotates freely and the brake pads are retracted sufficiently to allow movement of the tire and wheel assembly.
  2. Grasp each front tire at the top and bottom and move the wheel inward and outward while lifting the weight of the tire off the wheel bearing.
  3. If the tire and wheel hub is loose or does not rotate freely, install a new wheel hub. For additional information, refer to FRONT SUSPENSION or REAR SUSPENSION .
scientia non olet · About LEMON Manuals