Removal and Installation
WARNING: This page is about a different car, the 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
- Remove the transaxle. For additional information, refer to REMOVAL .
- Disconnect the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.
- Remove the 3 clutch slave cylinder bolts and the clutch slave cylinder.
- To install, tighten to 12 Nm (106 lb-in).
- To install, reverse the removal procedure.
- Bleed the air from the system. For additional information, refer to CLUTCH SYSTEM BLEEDING .