Removal and Installation
WARNING: This page is about a different car, the 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The gearshift lever boot and gearshift lever knob is one assembly.
- Separate the gearshift lever boot from the floor console.
- Cut the gearshift lever knob crimp ring and discard.
- Remove the gearshift lever knob and gearshift lever boot assembly.
- To install, reverse the removal procedure.
- Install a new gearshift lever knob crimp ring.
NOTE:
The gearshift lever boot has been removed for clarity.
NOTE:
A fully seated knob will conceal the knurled section on the gearshift lever. Failure to fully seat the gearshift knob may cause gearshift lever boot damage.