LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1374 (HVAC - Climate Control System) >> Removal And Installation >> Blower Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the blower motor electrical connector.
  2. Release the 2 blower motor vent tube clips and pull the vent tube down until it is disengaged from the heater core and evaporator core housing.
    3. NOTE: The carpet below the blower motor must be slightly repositioned to remove the blower motor.
  3. Rotate the blower motor counterclockwise to disengage it from the housing and remove the blower motor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals