Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the liftgate window glass is in the raised position.

Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
Disconnect the liftgate window latch ajar switch electrical connector.

NOTE: Mark the position of the liftgate window latch prior to removing the liftgate window latch bolts.

Remove the 2 bolts and the liftgate window latch.
- To install, tighten to 12 Nm (106 lb-in).
  
  Fig 1: Locating Liftgate Window Latch With Bolts
  Courtesy of FORD MOTOR CO.

NOTE: The liftgate window latch must be checked to make sure the latch is installed and aligned correctly.

To install, reverse the removal procedure.