LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Liftgate Release Switch - Liftgate Window >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
  2. Remove the 4 liftgate trim bezel nuts and remove the bezel from the liftgate.
    • To install, tighten to 8 Nm (71 lb-in).
    • Disconnect the liftgate window release switch electrical connector.
    • Using the appropriate tool, press the tabs and remove the liftgate window release switch.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals