LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1351 (Engine Controls - Electronic Engine Controls - 2.5L (Hybrid)) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the Throttle Body (TB). For additional information, refer to THROTTLE BODY .
  3. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector.
  4. Using a tool like KD Tool #58181 or Lisle T25 Torx Bit, remove the screw and the MAP  sensor.
    • To install, tighten to 3 Nm (27 lb-in).
    5. NOTE: Lubricate the MAP  sensor O-ring seal with clean engine oil.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals