Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
Remove the 3 windshield wiper mounting arm and pivot shaft assembly bolts and the windshield wiper mounting arm and pivot shaft assembly.
- To install, tighten to 9 Nm (80 lb-in).
  
  Fig 1: Checking Rear Height Motor Circuits For Short To Voltage
  Courtesy of FORD MOTOR CO.
Disconnect the windshield wiper motor electrical connector.
Remove the wiper motor assembly. For additional information, refer to WIPER MOTOR - WINDSHIELD .
To install, reverse the removal procedure.