LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Seat System - Seats) >> Removal And Installation >> Seat Track >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For component identification and locations, refer to SEAT - EXPLODED VIEW, FRONT .
  1. Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT  .
  2. Remove the safety belt buckle pretensioner.
    • Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
    • Detach the wiring harness pin-type retainer.
    • Route the wiring harness from between the seat track and cushion frame.
  3. Disconnect the electrical connectors, detach the wiring harness from the seat track.
    • If driver seat, disconnect the seat position sensor electrical connector.
    • If equipped, disconnect the power seat motor electrical connector.
    • Detach the seat harness electrical connector from the seat track.
      • Note wiring harness routing for correct installation.
  4. Remove the 4 seat track-to-cushion frame bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. To install, reverse the removal procedure.
    • Transfer components as necessary.
scientia non olet · About LEMON Manuals