LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Instrument Panel And Console) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering wheel down.
    2. NOTE: When prying on a component, a non-marring tool must be used or damage to the component may occur.
  2. With a non-marring instrument panel tool, release the instrument cluster finish panel clips.
  3. Remove the instrument cluster finish panel.
    • Disconnect the electrical connectors.
  4. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.
scientia non olet · About LEMON Manuals