LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1334 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Wheel Speed Sensor Ring - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Front Wheel Drive (FWD) vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING -- ESCAPE, ESCAPE HYBRID, MARINER & MARINER HYBRID .
  2. Remove the rear wheel hub nut.
    • To install, tighten to 290 Nm (214 lb-ft).
  3. Remove the sensor ring from the wheel hub.
  4. To install, reverse the removal procedure.

    All-Wheel Drive (AWD) vehicles 

  5. The rear wheel speed sensor ring is integral to the rear axle halfshaft and cannot be repaired separately. For additional information, refer to REAR DRIVE HALFSHAFTS .
scientia non olet · About LEMON Manuals