LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1313 (Rear Suspension System) >> Removal And Installation >> Wheel Knuckle - Front Wheel Drive (FWD) >> Installation

Wheel Knuckle - Front Wheel Drive (FWD): Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel bearing. For additional information, refer to WHEEL BEARING - FRONT WHEEL DRIVE (FWD) .
    2. NOTE: The joint area must be free of foreign material to make sure of correct clamping.
    NOTE: Align the notch on the cam nut with the index marks.
  2. Position the wheel knuckle and install a new wheel knuckle bolt and cam nut.
  3. Using a suitable tool, hold the cam nut stationary while tightening the new wheel knuckle bolt.
    • Tighten to 125 Nm (92 lb-ft).
  4. Position the lower ball joint into the wheel knuckle and install the new lower ball joint nut.
    • Tighten to 63 Nm (46 lb-ft).
  5. Install the coil spring. For additional information, refer to SPRING .
  6. Connect the stabilizer bar link and install the nut.
    • Tighten to 55 Nm (41 lb-ft).
  7. Position the wheel speed sensor harness and the sensor.
  8. Install the wheel speed sensor bolt and the 2 wheel speed sensor harness bolts.
    • Tighten the bolts to 9 Nm (80 lb-in).
  9. Connect the brake tube to the wheel cylinder.
    • Tighten to 17 Nm (150 lb-in).
  10. Install the brake hose bracket bolt.
    • Tighten to 22 Nm (16 lb-ft).
  11. Connect the parking brake cable to the brake backing plate and install the parking brake cable bracket bolt.
    • Tighten to 23 Nm (17 lb-ft).
  12. Install the brake shoes and brake drum. For additional information, refer to BRAKE SHOES .
    13. NOTE: Apply the brake to keep the wheel hub from rotating.
  13. Install a new wheel hub nut.
    • Tighten the nut to 290 Nm (214 lb-ft).
  14. Bleed the brake system. For additional information, refer to BRAKE SYSTEM BLEEDING .
  15. Check and, if necessary, align the rear end. For additional information, refer to GENERAL PROCEDURES .
scientia non olet · About LEMON Manuals