LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1298 (Automatic Transmission - Electronically Controlled Continuously Variable Transmission (ECVT) - (Hybrid)) >> In-Vehicle Repair >> Differential Seals - RH >> Removal

Differential Seals - RH: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

All Vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Turn the ignition to the OFF position.
  3. Remove the retainers and remove the LH splash shield.
    Fig 1: Locating LH Splash Shield And Splash Shield Retainers
    G06097824Courtesy of FORD MOTOR CO.
  4. Remove the drain plug and drain the transmission fluid.
    Fig 2: Locating Drain Plug
    G06097832Courtesy of FORD MOTOR CO.

    Front Wheel Drive (FWD) 

  5. Remove the intermediate shaft. For additional information, refer to REMOVAL AND INSTALLATION .

    All-Wheel Drive (AWD) 

  6. Remove the Power Transfer Unit (PTU). For additional information, refer to REMOVAL .

    All Vehicles 

  7. Using the Slide Hammer and RH Halfshaft Fluid Seal Remover, remove and discard the RH differential seal.
    Fig 3: Identifying Slide Hammer And RH Halfshaft Flid Seal Remover
    G06097843Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals