Special Tool(s)

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL SPECIFICATION

Courtesy of FORD MOTOR CO.	Aligner, Crankshaft Sensor 303-1417
Courtesy of FORD MOTOR CO.	Alignment Plate, Camshaft 303-465 (T94P-6256-CH)
Courtesy of FORD MOTOR CO.	Compressor, Piston Ring 303-D032 (D81L-6002-C)
Courtesy of FORD MOTOR CO.	Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C)
Courtesy of FORD MOTOR CO.	Heavy Duty Floor Crane 014-00071 or equivalent
Courtesy of FORD MOTOR CO.	Holding Tool, Crankshaft Damper 303-1416
Courtesy of FORD MOTOR CO.	Installer, Camshaft Front Oil Seal 303-096 (T74P-6150-A)
Courtesy of FORD MOTOR CO.	Installer, Connecting Rod 303-462 (T94P-6136-AH)
Courtesy of FORD MOTOR CO.	Installer, Crankshaft Rear Main Oil Seal 303-328 (T88P-6701-B1)
Courtesy of FORD MOTOR CO.	Spreader Bar 303-D089 (D93P-6001-A3) or equivalent
Courtesy of FORD MOTOR CO.	Timing Peg, Crankshaft TDC 303-507