Door Alignment - Rear
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
All alignments
- Remove the door latch striker plate.
Rear door in and out, up and down alignment
- Loosen, but do not remove, the rear door hinge-to-rear door fasteners enough to allow door alignment.
Rear door fore, aft and tilt alignment
- Position aside the B-pillar panel.
- Loosen, but do not remove, the upper rear door hinge-to-body fasteners enough to allow door alignment.
- Loosen, but do not remove, the lower rear door hinge-to-body fasteners enough to allow door alignment.
All alignments
- Adjust the door. For additional information, refer to BODY REPAIRS .
- Tighten the door fasteners.
- Tighten the rear door hinge-to-rear door bolts to 30 Nm (22 lb-ft).
- Tighten the rear door hinge-to-body bolts to 25 Nm (18 lb-ft).
Rear door fore, aft and tilt alignment
- Install the B-pillar trim panel.
All alignments
- Install and adjust the door striker as necessary. For additional information, refer to
BODY REPAIRS
.
- Tighten the door latch striker plate bolts to 22 Nm (16 lb-ft).