LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (Interior Trim And Ornamentation) >> Removal And Installation >> B-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front seats in the full forward position.
  2. Remove the safety belt D-ring cover and remove the D-ring bolt.
    NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Position the front and rear door weatherstrips aside.
  4. Remove the front door scuff plate trim panel. For additional information, refer to Removal and Installation .
  5. Remove the rear door scuff plate trim panel. For additional information, refer to Removal and Installation .
  6. Remove the lower B-pillar trim panel.
    • Lift the lower area of the lower B-pillar trim panel and pull inward toward the center of the vehicle.
    • Slide the lower B-pillar trim panel down to disengage it from the upper B-pillar trim panel.
  7. Remove the upper B-pillar trim panel.
    • Remove the screw cover.
    • Remove the screw.
    • Remove the push-pin with the B-pillar trim panel.
    Fig 1: Locating B-Pillar Trim Panel Push-Pin
    G06271393Courtesy of FORD MOTOR CO.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals