LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Engine Emission Control System - 2.5L (Except Hybrid)) >> Removal And Installation >> Crankcase Vent Oil Separator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Release the coolant bypass hose from the clip.
  3. Remove the 8 bolts and the crankcase vent oil separator and gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    • Clean the engine block mating surface.
scientia non olet · About LEMON Manuals