LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1251 (Fuel Charging System & Fuel Control System - 3.0L (4V)) >> Removal And Installation >> Fuel Rail >> Installation

Fuel Rail: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 6 fuel injectors and the 6 fuel injector clips into the fuel rail.
    NOTE: Use O-ring seals that are made of special fuel-resistant material. The use of ordinary O-ring seals can cause the fuel system to leak. Do not reuse the O-ring seals.
    NOTE: Install new fuel injector O-ring seals and lubricate them with clean engine oil.
  2. Install the fuel rail and fuel injectors as an assembly.
  3. Install the 4 fuel rail bolts.
    • Tighten to 10 Nm (89 lb-in).
  4. Connect the 6 fuel injector electrical connectors.
  5. Attach the engine wire harness pin-retainer to the fuel rail.
  6. Attach the 5 fuel charging wire harness pin-retainers to the fuel rail.
  7. Connect the fuel tube-to-fuel rail quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
  8. Install the upper intake manifold. For additional information, refer to INSTALLATION .
  9. Connect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals