LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1242 (Manual Transaxle) >> In-Vehicle Repair >> Halfshaft Seal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: New halfshaft oil seals should be installed any time the halfshafts are removed. Failure to install new halfshafts seals may result in transaxle oil leak(s) and damage to the transmission may occur.
  1. Remove the transaxle drain plug and drain the fluid.
  2. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to REMOVAL .
  3. Using the Slide Hammer with the Stator Case Bearing Remover, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.
    Fig 1: Identiyfing Slide Hammer And Stator Case Bearing Remover
    G06275880Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals