LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1241 (Automatic Transaxle External Controls (Hybrid)) >> Removal And Installation >> Selector Lever >> Removal

Selector Lever: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the selector lever cable end from the selector lever.
    Fig 1: Identifying Selector Lever Cable Lever
    G06275674Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    Fig 2: Identifying Tab On Selector Lever Cable
    G06275675Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 3: Locating Electrical Connector
    G06275783Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    Fig 4: Locating Selector Lever Nuts
    G06275784Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals