LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1241 (Automatic Transaxle External Controls (Hybrid)) >> Removal And Installation >> Selector Lever Cable >> Installation

Selector Lever Cable: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the selector lever cable in place and install the 2 nuts.
    • Tighten to 9 Nm (80 lb-in).
    Fig 1: Locating Selector Lever Cable Grommet Nuts
    G06275667Courtesy of FORD MOTOR CO.
  2. Position the insulation blanket in place over the selector lever cable grommet.
    Fig 2: Positioning Insulation Blanket Away From Bulkhead
    G06275666Courtesy of FORD MOTOR CO.
  3. Position back the RCM wiring harness and install the fasteners on the studs.
    Fig 3: Locating Wiring Harness Fasteners
    G06275665Courtesy of FORD MOTOR CO.
  4. Install the selector lever cable in the retainer.
    Fig 4: Locating Selector Lever Cable
    G06275770Courtesy of FORD MOTOR CO.
  5. Install the selector lever cable in the bracket. Be sure the tabs are locked in place.
    NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
    Fig 5: Locating Selector Lever Cable Tabs
    G06275769Courtesy of FORD MOTOR CO.
  6. Connect the selector lever cable end on the manual control lever.
    Fig 6: Connecting Selector Lever Cable End On Manual Control Lever
    G06275504Courtesy of FORD MOTOR CO.
  7. Install the RCM  . For additional information, refer to INSTALLATION .
  8. Install the heater core and evaporator core housing. For additional information, refer to REMOVAL AND INSTALLATION .
  9. Adjust the selector lever cable.
scientia non olet · About LEMON Manuals