LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1240 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Bezel - MKZ >> Installation

Selector Lever Bezel - MKZ: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the selector lever trim ring in the selector lever bezel.
    Fig 1: Locating Selector Lever Trim Ring
    G06275725Courtesy of FORD MOTOR CO.
  2. Install the selector lever boot in the selector lever bezel.
    NOTE: When installing the selector lever boot, be sure it is in the correct position or the selector lever boot can not be installed on the selector lever knob. If needed, align the selector lever knob to the selector lever boot when installing the boot.
    Fig 2: Installing Selector Lever Boot In Selector Lever Bezel
    G06275726Courtesy of FORD MOTOR CO.
  3. Position the selector lever bezel in place and connect the electrical connector.
    Fig 3: Locating Selector Lever Bezel & Electrical Connector
    G06275722Courtesy of FORD MOTOR CO.
  4. Position the selector lever bezel in place and install it onto the center console.
    Fig 4: Locating Emergency Brake Lever
    G06275721Courtesy of FORD MOTOR CO.
  5. Position the selector lever knob onto the selector lever and install the screws.
    Fig 5: Locating Selector Lever Knob Screws
    G06275729Courtesy of FORD MOTOR CO.
  6. Slide the selector lever knob bezel up and install it on the selector lever knob.
    Fig 6: Sliding Selector Lever Knob Bezel Up
    G06275730Courtesy of FORD MOTOR CO.
  7. Install the LH and RH console finish moldings.
Fig 7: Locating Console Finish Moldings
G06275718Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals