LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1240 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever - MKZ >> Removal

Selector Lever - MKZ: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the selector lever bezel. For additional information, refer to Removal .
  2. Remove the PRNDL electrical connector from the RH side of the center console.
    Fig 1: Locating PRNDL Electrical Connector
    G06275683Courtesy of FORD MOTOR CO.
  3. Remove the LH and RH center console trim covers.
    NOTE: LH shown in illustration, RH similar.
    Fig 2: Locating Center Console Trim Cover
    G06275684Courtesy of FORD MOTOR CO.
  4. Remove the LH and RH center console-to-selector lever screws.
    NOTE: LH shown in illustration, RH similar.
    Fig 3: Locating Center Console-To-Selector Lever Screws
    G06275685Courtesy of FORD MOTOR CO.
  5. Disconnect the selector lever cable end from the selector lever ball stud.
    Fig 4: Locating Selector Lever Cable
    G06275686Courtesy of FORD MOTOR CO.
  6. Disconnect the selector lever electrical connector.
    Fig 5: Locating Selector Lever Electrical Connector
    G06275687Courtesy of FORD MOTOR CO.
  7. Remove the 4 selector lever nuts.
    Fig 6: Locating Selector Lever Nuts
    G06275688Courtesy of FORD MOTOR CO.
  8. Position the selector lever off of the studs, release the tab on the selector lever cable and remove it from the selector lever.
    9. Fig 7: Positioning Selector Lever Off Of Studs
    G06275689Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals