LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1239 (Engine Controls - Electronic Engine Controls - 3.5L) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the LH catalytic converter. For additional information, refer to REMOVAL AND INSTALLATION (LH) .
  3. Remove the bolt, nut and the heat shield.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the rubber grommet cover.
  5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
  6. Remove the bolt and the CKP  sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  7. To install, reverse the removal procedure.
  8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals