LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1237 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Ignition Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For non-functional ignition lock cylinders, the steering column lock module has to be replaced. For additional information, refer to REMOVAL AND INSTALLATION .
  1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION .
  2. Turn the ignition key to the ACC position.
  3. Using a suitable tool, press the ignition lock cylinder release button and remove the ignition lock cylinder.
  4. If a new lock cylinder with keys is replaced, the new PATS keys must be programmed. For additional information, refer to INTEGRATED KEYHEAD TRANSMITTER (IKT) KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT or INTEGRATED KEYHEAD TRANSMITTER (IKT) KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals