LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1237 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 6 (Fusion)/2 (Milan/MKZ) radiator grille pin-type retainers and the 4 radiator grille bolts.
  2. For MKZ, disconnect the secondary hood latch release cable from the hood latch.
  3. Remove the 2 hood latch bolts and position the hood latch aside.
    • To install, tighten to 12 Nm (106 lb-in).
    NOTE: Pull up on the radiator grille to gain access to the hood latch.
    NOTE: Mark the hood latch position prior to removal of the hood latch bolts.
  4. Disconnect the hood latch release cable and remove the hood latch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals