Disassembly and Assembly

All vehicles 

1. Remove the 60 percent rear seat backrest. For additional information, refer to SEAT BACKREST - REAR .
2. While lifting up on the head restraint, push in the hole, push in the button and remove the head restraint.
   • Repeat for the other head restraint.
   Fig 1: Locating Head Restraint Buttons

   Courtesy of FORD MOTOR CO.
3. Release the 4 tabs (2 shown) and remove the striker cover.
   Fig 2: Locating Striker Cover Tabs

   Courtesy of FORD MOTOR CO.
4. Release the backrest cover from around the striker opening.
   Fig 3: Locating Backrest Cover

   Courtesy of FORD MOTOR CO.

   Hybrid vehicle 

5. Remove 2 pin-type retainers and the duct end seal.
   Fig 4: Locating Pin-Type Retainers And Duct End Seal

   Courtesy of FORD MOTOR CO.

   All vehicles 

6. Separate the backrest cover.
   1. Disengage the lower J-strips.
      • Slide the heat deflector out from between the backrest frame and backrest cover, if equipped.
   2. Disengage the 2 J-clips.
   3. From in the opening, disengage the backrest cover clip and unwrap the backrest cover from around the backrest frame.
   4. Remove the 2 pin-type retainers.
   Fig 5: Identifying J-Strips, Backrest Cover Clip, Frame And Pin-Type Retainers

   Courtesy of FORD MOTOR CO.
7. Separate the 4 pin-type retainers attaching the armrest pocket cover to the backrest frame.
   Fig 6: Locating Pin-Type Retainers

   Courtesy of FORD MOTOR CO.
8. Remove the 4 armrest-to-backrest bolts and armrest assembly.
   • For installation, adjust the armrest horizontally as needed for good fit.
   • To install, tighten to 10 Nm (89 lb-in).
9. Disassemble the armrest assembly in the following sequence.
   1. Remove the cup holder rubber insert.
   2. Remove the 2 pin-type retainers and cup holder.
   3. Remove 2 armrest pivot bolts and armrest bracket.
   • To install, tighten to 10 Nm (89 lb-in).
10. Disengage 2 backrest cover clips in the armrest pocket.
    Fig 7: Locating Backrest Cover Clips

    Courtesy of FORD MOTOR CO.
11. Invert the backrest cover up as far as it will go.
    • Separate the hook-and-loop strips and remove all rows of hog rings working up the backrest.
    NOTE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.
12. Under the backrest foam pad, squeeze the ends of the head restraint guide sleeves together and remove.
    NOTE: The head restraint guide sleeves are keyed and will not interchange. To assemble, install the head restraint guide sleeve with the button on the LH side.
13. Remove the backrest cover and foam pad from the backrest frame.
14. To assemble, reverse the disassembly procedure.