Antenna Cable - Satellite Radio: Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Both cables
- Overlay the new satellite radio antenna cable on the vehicle wiring harness, following the routing of the original cable.
- Secure the new AM/FM antenna cable with tape or zip ties, as necessary.
- For the front satellite radio antenna cable on vehicles with navigation, secure the splitter using the built-in push-pins.
- Connect the front-to-rear satellite radio antenna cable connection at the RH kick panel.
Front cable
- Connect the front AM/FM antenna cable to the ACM .
- Install the ACM
. For additional information, refer to AUDIO CONTROL MODULE (ACM) - FUSION, MILAN or AUDIO CONTROL MODULE (ACM) - MKZ .
Rear cable
- Install the enable circuit.
- Insert the enable circuit CME44 (BU) into C237-25.
- Install the pin retainer into the inside of the male side of the connector.
- Connect C237.
- Connect the rear satellite radio antenna cable to the antenna.
- Tighten the bolt to 8 Nm (71 lb-in).
- Install the LH and RH assist handles, and the LH and RH C-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Install the RH front and RH rear sill panels.