LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1228 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Removal

Knock Sensor (KS): Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Cylinder head-mounted 

  1. Disconnect the Knock Sensor (KS) electrical connector.
  2. Remove the bolt and the KS  .

    Engine block-mounted 

  3. Remove the lower intake manifold. For additional information, refer to REMOVAL .
  4. Disconnect the KS  electrical connector.
  5. Remove the bolt and the KS  .
scientia non olet · About LEMON Manuals