LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1212 (Information Center - Instrumentation, Message Center And Warning Chimes) >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the RUN mode (do not start the engine).
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
  3. To disable the seating position, buckle then unbuckle the safety belt 3 times, ending in the unbuckled state.
    • After Step 3, the safety belt warning indicator illuminates for 3 seconds.
    NOTE: Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off.
  4. Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt. This enables the Belt-Minder® if disabled and disables the Belt-Minder® if enabled.
    • This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the safety belt warning indicator flashing 4 times per second for 3 seconds again.
  5. The safety belt warning indicator flashing 4 times per second for 3 seconds provides confirmation that the Belt-Minder® is disabled.
  6. The following sequence of events confirms the Belt-Minder® is enabled:
    • flashing of the safety belt warning indicator 4 times per second for 3 seconds
    • 3 seconds with the safety belt warning indicator off
    • flashing of the safety belt warning indicator 4 times per second for 3 seconds again
  7. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals