LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1211 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening cover by pulling straight outward.
    NOTE: The steering column opening cover is held in place by tabs that clip to the instrument panel.
  2. Remove the upper steering column shroud.
    NOTE: Release the upper steering column shroud, by pressing inward on the sides of the shroud and lifting upwards.
  3. Release the tilt lever, remove the 3 lower steering column shroud screws and then the shroud.
  4. Disconnect the multifunction switch electrical connector.
  5. Remove the 2 multifunction switch screws and the switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals