LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1210 (Exterior Lighting System) >> Removal And Installation >> Reversing Lamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the fasteners and the lower engine splash shield.
  3. Disconnect the electrical connector and remove the reversing lamp switch.
    • To install, tighten to 24 Nm (18 lb-ft).
    NOTE: Discard the reversing lamp switch gasket.
  4. To install, reverse the removal procedure.
    • Install a new reversing lamp switch gasket.
    • Check the transmission fluid and fill as necessary. For additional information, refer to TRANSAXLE DRAINING AND FILLING .
scientia non olet · About LEMON Manuals