Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

For Hybrid vehicles, remove the headlamp assembly. For additional information, refer to Removal and Installation .
For non-Hybrid vehicles, remove the 4 pin-type retainers and position the fender splash shield aside.

Fig 1: Locating Fender Splash Shield Aside Pin-Type Retainers
Courtesy of FORD MOTOR CO.
For non-Hybrid vehicles, disconnect the parking/turn lamp electrical connector.
Remove the front parking lamp socket from the headlamp assembly.
- Remove the front parking lamp bulb.
To install, reverse the removal procedure.