Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Parcel shelf mounted
- Disconnect the high mounted stoplamp electrical connector from within the luggage compartment.
- Push the high mounted stoplamp rearward to disengage the forward tabs and remove the high mounted stoplamp.
Spoiler mounted
- Remove the luggage compartment lid trim panel.
- Remove the 2 rubber access covers.
- Remove the 2 screws and the high mounted stoplamp.
- Disconnect the electrical connector.
Luggage compartment lid mounted
- Remove the luggage compartment lid trim panel.
- Remove the 4 nuts and the luggage compartment lid molding.
- Disconnect the electrical connectors.
- Remove the 4 nuts and the high mounted stoplamp bracket.
- Release the 2 tabs and remove the high mounted stoplamp.
- Disconnect the electrical connector.
All vehicles
- To install, reverse the removal procedure.