LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1210 (Exterior Lighting System) >> Removal And Installation >> Headlamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel side finish panel.
  2. Release the tabs and remove the headlamp switch and bezel assembly.
    • Disconnect the electrical connector.
    NOTE: The headlamp switch bezel is removed by pushing from behind.
  3. Release the tabs and separate the headlamp switch from the bezel.
    NOTE: The 3 retaining tabs on the headlamp switch are located at approximately the 3, 6 and 11 o'clock positions when viewed from the front.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals