LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1177 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan may cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the exhaust Y-pipe. For additional information, refer to EXHAUST SYSTEM .
  3. Drain the engine oil and install the drain plug.
    • Tighten to 26 Nm (19 lb-ft).
  4. Remove and discard the oil filter.
  5. Remove the access cover.
    Fig 1: Locating Access Cover With Bolts
    G06095610Courtesy of FORD MOTOR CO.
  6. Remove the 2 oil pan-to-transaxle bolts.
  7. Remove the 15 bolts and the oil pan.
    • Remove and discard the oil pan gasket.
scientia non olet · About LEMON Manuals