LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1176 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Exhaust Manifold >> Removal

Exhaust Manifold: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the exhaust flexible pipe. For additional information, refer to REMOVAL .
  3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
  4. Remove the 4 exhaust manifold heat shield bolts and the heat shield.
  5. If equipped, detach the block heater wire harness retainer from the exhaust manifold stud.
  6. Remove and discard the 7 exhaust manifold nuts.
  7. Remove the exhaust manifold and discard the exhaust manifold gasket.
  8. Remove and discard the 7 cylinder head studs.
  9. Clean and inspect the exhaust manifold. For additional information, refer to EXHAUST MANIFOLD CLEANING AND INSPECTION .
scientia non olet · About LEMON Manuals