LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1173 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P0722: Output Shaft Speed (OSS) Sensor Circuit No Signal

DTC P0722: Output Shaft Speed (OSS) Sensor Circuit No Signal

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0722: OUTPUT SHAFT SPEED (OSS) SENSOR CIRCUIT NO SIGNAL

Description:  The OSS sensor failed to provide a signal to the powertrain control module (PCM) upon initial movement of vehicle.
Possible Causes: 
  • Damaged OSS connector
  • Damaged OSS sensor, or not installed correctly
  • Harness intermittently short or open
Diagnostic Aids:  Check the wiring, connector, and sensor for damage.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Manual Transmission - - GO to PINPOINT TEST DP .
Automatic Transmission Refer to the Diagnostic Trouble Code (DTC) Index in the appropriate AUTOMATIC TRANSMISSION/TRANSAXLE article to continue diagnosis.