P052A - Cold Start Camshaft Position Timing Over-Advanced (Bank 1)

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

P052A - COLD START CAMSHAFT POSITION TIMING OVER-ADVANCED (BANK 1)

Description:	The powertrain control module (PCM) monitors the variable camshaft timing (VCT) position for an over-advanced camshaft timing during cold start up. The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position.
Possible Causes:	Camshaft timing incorrectly set Continuous oil flow to the VCT piston chamber VCT solenoid valve stuck open Camshaft advance mechanism binding (VCT unit)
Diagnostic Aids:	This DTC is a functional check of the VCT unit. Diagnose any base engine concerns related to the engine oil pressure or engine timing. Refer to the OIL PRESSURE TEST , to check the engine oil pressure. Refer to the TIMING DRIVE COMPONENTS , to check the engine timing.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	GO to PINPOINT TEST HK .	GO to PINPOINT TEST HK .