LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1152 (Automatic Transmission External Controls) >> Diagnostic Tests >> External Controls >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern by operating the transmission external control.
  2. Visually inspect for obvious signs of mechanical and electrical damage. Refer to the following chart:
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Damaged brake shift interlock actuator (BSIA)
    • Damaged transmission control (TC) switch
    • Failed fuse(s):
      • 2.11 (15A)
      • 2.6 (10A)
    • Damaged wiring harness
    • Loose or corroded connections
  3. If the concern is not visually evident, determine the symptom. Go to Symptom Chart - External Controls  or Go to Symptom Chart - Noise, Vibration and Harshness (NVH) .