LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1147 (Hydraulic Brake Actuation) >> Removal And Installation >> Brake Pedal and Bracket >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When disconnecting the brake booster rod, note the orientation of the rod. Incorrect installation of the booster rod may result in brake booster damage.
  1. Release the fuse block assembly from the brake pedal bracket and position aside.
    2. Fig 1: Identifying Brake Pedal Bracket
    GF0012277Courtesy of FORD MOTOR CO.
  2. Disconnect the brake booster push rod.
    • Remove the brake pedal cotter pin cover.
    • Remove the brake pedal cotter pin.
    • Position the stoplamp switch aside.
    • Remove the brake booster push rod bushing.
    • Disconnect the brake booster push rod from the brake pedal pin.
  3. Remove the 2 brake pedal bracket nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Remove the 4 brake booster nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Remove the brake pedal and bracket assembly.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals