Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

Release the wheel speed sensor wiring harness from the brake flexible hose.
Remove the brake caliper flow bolt and discard the 2 copper washers.
- To install, tighten bolt to 40 N.m (30 lb-ft).
- Use new copper washers.
Disconnect the brake tube fitting from the brake flexible hose.
- To install, tighten to 17 N.m (13 lb-ft).
Remove the brake flexible hose retaining clip and the brake flexible hose.
To install reverse the removal procedure.
- Bleed the brake caliper. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article for component bleeding.