LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Electronic Engine Controls - Diesel Engine) >> Removal And Installation >> Exhaust Pressure Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  3. Disconnect the exhaust pressure (EP) sensor electrical connector.
    4. Fig 1: Exhaust Pressure (EP) Sensor Electrical Connector
    GF0012088Courtesy of FORD MOTOR CO.
    CAUTION: Support the exhaust pressure (EP) sensor tube flange nut when removing the EP sensor, or damage to the tube may occur.
  4. Remove the EP sensor.
    • To install, tighten to 20 Nm (15 lb-ft).
    5. Fig 2: Exhaust Pressure (EP) Sensor
    GF0012089Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals