LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1136 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the solenoid body connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the transmission internal wiring harness.
    1. Install the 2 screws.
    2. Connect the TFT sensor connector.
    3. Connect the solenoid connectors.
    3. Fig 1: Transmission Fluid Temperature Sensor Electrical Connector And Solenoid Electrical Connectors
    GF0006824Courtesy of FORD MOTOR CO.
    NOTE: The O-ring must be installed in the top slot.
  3. Install a new solenoid body electrical connector O-ring.
    4. Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  4. Install the solenoid body. For additional information, refer to Solenoid Body Assembly .
scientia non olet · About LEMON Manuals