Forward Clutch Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Soak all friction clutch plates in clean transmission fluid.

Remove and discard the 2 seals and remove the No. 7 thrust washer.

Fig 1: Identifying Seals And Thrust Washer

Courtesy of FORD MOTOR CO.

Remove the No. 8 forward clutch thrust bearing.

Fig 2: Identifying Forward Clutch Thrust Bearing

Courtesy of FORD MOTOR CO.

Remove the snap ring and the forward clutch plates.

Fig 3: Locating Snap Ring And Forward Clutch Plates

Courtesy of FORD MOTOR CO.

Using the special tools, remove the snap ring.

Fig 4: Identifying Snap Ring With Special Tools

Courtesy of FORD MOTOR CO.

NOTE: Note the orientation of the return spring.

Remove the forward clutch balance piston and the return spring. Discard the forward clutch balance piston.

Fig 5: Locating Forward Clutch Balance Piston Return Spring

Courtesy of FORD MOTOR CO.

Remove and discard the forward clutch piston.

Fig 6: Locating Forward Clutch Piston

Courtesy of FORD MOTOR CO.

Clean and inspect all components for damage.