LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1132 (Glow Plug System 6.0L (99P E-Series)) >> Removal And Installation >> Glow Plug Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  3. Remove the 2 nuts for the glow plug module.
    • Tighten to 8 Nm (71 lb-in).
    4. Fig 1: Glow Plug Module Nuts
    GF0012022Courtesy of FORD MOTOR CO.
  4. Position the glow plug module and disconnect the glow plug module electrical connectors. Remove the glow plug module.
    5. Fig 2: Glow Plug Module Electrical Connectors
    GF0012023Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals