Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the RH exhaust manifold, 8 spacers and 8 new bolts. Tighten the bolts in the sequence shown.
- Tighten to 38 Nm (28 lb-ft).

Fig 1: Exhaust Manifold Bolt Tightening Sequence

Courtesy of FORD MOTOR CO.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the 2 new RH exhaust manifold-to-turbocharger adapter pipe nuts.
- Tighten to 27 Nm (20 lb-ft).
Install the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.