LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Engine - 6.8L) >> In-Vehicle Servicing >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new valve seal with clean engine oil prior to installation.
  1. Using the special tools, install the new valve stem seal.
    2. Fig 1: Installing Seal
    GF0011654Courtesy of FORD MOTOR CO.
  2. Install the valve spring. For additional information, refer to Valve Springs .
scientia non olet · About LEMON Manuals