LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Engine - 6.8L) >> In-Vehicle Servicing >> Oil Cooler >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to ENGINE COOLING article.
  2. Drain the engine oil.
  3. Disconnect the 2 coolant hoses from the engine oil cooler.
  4. Remove and discard the oil filter.
    • To install, tighten to 16 Nm (12 lb-ft).
    5. CAUTION: If metal, aluminum or foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, Refer to ENGINE SYSTEM - GENERAL INFORMATION article. Failure to follow this instruction may result in additional engine damage.
  5. Remove the threaded insert and discard the oil cooler.
    • Inspect and discard the oil cooler.
    • To install, tighten to 58 Nm (43 lb-ft).
  6. To install, reverse the removal procedure.
    • Install a new oil cooler.
    • Fill the crankcase with clean engine oil prior to filling the cooling system.
scientia non olet · About LEMON Manuals