LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> Transmission Insulator And Retainer >> Removal

Transmission Insulator And Retainer: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 2 nuts.
    3. Fig 1: Insulator Nuts
    GF0012359Courtesy of FORD MOTOR CO.
  3. Position a high-lift transmission jack under the transmission.
  4. Raise the transmission until the retainer studs are separated from the transmission support crossmember.
    5. Fig 2: Retainer Studs
    GF0012365Courtesy of FORD MOTOR CO.
  5. Remove the bolts and the insulator and retainer.
    6. Fig 3: Insulator Bolts
    GF0012360Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals